Home > Question Regarding > Question Regarding 24-pin Connector

Question Regarding 24-pin Connector

Technically, a 20-pin ATX connector can be plugged straight into a 24-pin motherboard socket, leaving pins 11, 12, 23, and 24 unconnected. I am talking about the 24 pin connector on the right side of the board. Dhindsa on October 5, 2014 Failed to get answers. Similar Threads - Question regarding connector Little question regarding GX GAMING CAVIMANUS audio panel. http://olivettipc.com/question-regarding/question-regarding-hdd.html

There was obviously a good reason to add extra four wires to the main cable-- it was done to support higher current requirements. If you exceed current rating CudaJoe02-26-2014, 02:49 AMmaking a new thread. Answer: Oh definately yes the fan in this power supply should always spin, because it is not thermally controlled. Back then I paid quite a lot for this awesome Silverstone Zeus, and it was the last in stock too, in the entire mall!

It has the last four pins on a detachable section that slips out, so you can plug it into an older motherboard (see the diagram above). This 22nd edition offers beefed-up coverage of the newest hardware innovations and maintenance techniques, plus more than two hours of new video.   Scott Mueller delivers practical answers about PC processors, sphinx03-09-2015, 01:50 AMis mandatory to connect the 4 -pin power . Well actually a part of me is in denial that the PSU is dying lol.

Just spend the extra $10 and get a better one, that's my recommendation. There are probably a few others out there as well, so it might be worth searching around. You would now use the reset switch to turn ON the system. I assume I would need to buy an adaptor?

I mean theres only two usb headers so not much options with connecting it to the mobo. All rights reserved. I think it only had 1 lead with 2 Molex (IDE) connectors, but I honestly can't remember for sure- sorry. Scott has been featured in Forbes magazine and has written several articles for PC World magazine, Maximum PC magazine, the Scott Mueller Forum, various computer and automotive newsletters, and the Upgrading

Hmmm could have been the PW On switch that wasn't plugged in properly after all... If it was half-way plugged in, that could cause a problem though. by Jedson3614 › Dungeon Siege III by michaeltibbsjr › Sapphire RX 460 2GB Single Fan D5 OC by sepiashimmer › NZXT Technologies Kraken X41 140mm All-In-One Liquid Cooling System... See all 4 answers 0 vote votes Question: Will this work with a Dell optiplex 755 mini tower Answer: I don`t believe it will fit the case.I bought one for a

This is a very quick and easy way to test the pw ON switch without having to spend any money. Advertisement Recent Posts Black screen theborg replied Feb 22, 2017 at 1:08 PM Comparing excels draceplace replied Feb 22, 2017 at 1:06 PM Make Four Words Gr3iz replied Feb 22, 2017 On the top right of the board there is a standard CPU power connector and next to that a 4 pin power connector as well. Yes NoSend feedback Sorry we couldn't be helpful.

Please return it immediately. http://olivettipc.com/question-regarding/question-regarding-a-grid.html Alternatively, you can buy a 24 to 20 pin adapter. With the cables I mentioned above, will I be able to use the 770 with my PSU, or will I have to buy one with more connectors? 2 commentsshareall 2 commentssorted Today's motherboards are using PWR_OK signal for proper timing.

Many new ATX12V v2 compliant PC power supplies come with a dual 24/20 (sometimes called 20+4) connector for backward compatibility. and if you could with the PSU put the power rating (read: 12v xxA | Example: 12v 32A) getsugatenso, Dec 21, 2008 #11 crjdriver Moderator Joined: Jan 2, 2001 Messages: It's been two days, and so far my system runs without a hitch Also, I'm using a Silverstone Zeus series. check my blog Now when I reconnect the 24 pin connector to the motherboard and take a voltage reading at pin 8 the voltage reading dropped to 3.79 volts.

My power supply comes with a 24 pin connector. I checked the 24 pin power connector from the PSU to the motherboard and tried to re-fit it again. All other voltage lines like the 12,5, and 3 volts are within specs whether disconnected or connected to the motherboard.

Full Review NZXT Technologies Kraken X41 140mm All-In-One Liquid Cooling System...

Can't find your answer ? What Corsair Module or Modules will work with my MB? Also, you may want to start a new thread regarding your OC failures. Why do you say that?

Thanks, N0cturnal N0cturnal View Public Profile Find all posts by N0cturnal #2 08-06-2009, 07:34 PM RAM GUY Corsair Product Guru RAM GUY's PC Specs Join Date: Apr 2001 My question is the 24 pin connector can be split into 16 pin and 8 pin connector. I need to go re-read that. http://olivettipc.com/question-regarding/question-regarding-router.html I...

Also see our tutorial on laptop batteries. For such an application, the PSU typically has to be >400W, or otherwise you may not have enough current rating on 12 volt output. Emerging interfaces such as mSATA, USB 3.1, and M.2 Updated coverage of building PCs from scratch—from choosing and assembling hardware through BIOS setup and troubleshooting       Vista previa del solved PC Not Starting - Burned Out 24pin Connector - Replace Mobo?

I thought I read that in the mobo manual not to hook up the 4 pin to the main motherboard power supply. These adapters actually make things worse because they add extra resistance between PSU and the load causing more voltage drop.

Another issue to keep in mind is PSUs built prior Modern systems may have booting problems and may not work without properly functioning PWR_OK signal. Since 1982, MTR has produced the industry’s most in-depth, accurate, and effective seminars, books, articles, videos, and FAQs covering PC hardware and data recovery.

The frequent questions are how to connect a PC power supply with 20-pin main connector to a 24-pin motherboard or visa versa, and will a 20 pin plug work in 24 CONNECTING a POWER SUPPLY TO an ATX MOTHERBOARD WITH DIFFERENT PIN NUMBERS Home | Tutorial | Topologies | SMPS design | Software | PCB design | Computer PSU | UPS | This site is completely free -- paid for by advertisers and donations. So when you said 16 pin and 8 pin, you threw me off a little.

The manual says DO NOT PLUG THIS INTO YOUR MOBO, you may damage it. NemesisChild02-25-2014, 09:01 PMCudaJoe, please list your system components.